Difference between revisions of "1166 - DSP Mainboard"
From eMDeeWiki
Jump to navigationJump to search| Line 7: | Line 7: | ||
<ol> | <ol> | ||
| − | <li>Move RJ-45 connector closer to the center of the board (about 400-500 mils from each edge).</li> | + | <li>Move RJ-45 connector closer to the center of the board (about 400-500 mils from each edge). I mistakenly said to move it to the right, but I meant to the left (I was looking at the connector from the back of the box). What I want to do is get it away from the edge of the box as much as possible.</li> |
<li>Move JTAG connector up and to the right side to avoid internal interference</li> | <li>Move JTAG connector up and to the right side to avoid internal interference</li> | ||
| − | <li></li> | + | <li>The PoE module clearance looks OK as long as the model on the PCB is accurate. If the board is thicker or there are components on the back side of the module, it may interfere with the box. Please double-check the accuracy of the PoE model with the data sheet to make sure we have enough clearance on both sides.</li> |
| + | <li>It's difficult to find cable connectors like we want that are not 100 mil spacing. I found some similar that are 79 mil spacing and some that are 50 mil. The datasheets are linked below, let me know which style will work better.</li> | ||
</ol> | </ol> | ||
== Datasheet Links == | == Datasheet Links == | ||
| + | |||
| + | [http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=S9131-ND 50mil x 100 mil header] | ||
| + | |||
| + | [http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=S9036-ND 79 mil header] | ||
[http://focus.ti.com/lit/ds/symlink/tms320c6424.pdf (U1)DSP: TMS320C6424] | [http://focus.ti.com/lit/ds/symlink/tms320c6424.pdf (U1)DSP: TMS320C6424] | ||
Revision as of 17:14, 12 March 2010
General Info
Part Number: 10684
PCB Layout To-Do List
- Move RJ-45 connector closer to the center of the board (about 400-500 mils from each edge). I mistakenly said to move it to the right, but I meant to the left (I was looking at the connector from the back of the box). What I want to do is get it away from the edge of the box as much as possible.
- Move JTAG connector up and to the right side to avoid internal interference
- The PoE module clearance looks OK as long as the model on the PCB is accurate. If the board is thicker or there are components on the back side of the module, it may interfere with the box. Please double-check the accuracy of the PoE model with the data sheet to make sure we have enough clearance on both sides.
- It's difficult to find cable connectors like we want that are not 100 mil spacing. I found some similar that are 79 mil spacing and some that are 50 mil. The datasheets are linked below, let me know which style will work better.
Datasheet Links
Implementing DDR2 PCB Layout on the TMS320C6424 DSP
(U10,12,13)Supervisory Circuit
