View source for USB8x8 Setup

== USB8x8 Windows 10 Setup and Verification ==

Follow these instructions to setup and verify the operation of the USB8x8 audio interface.  Before you begin, make sure that no other applications that use the sound device are running (stop CGCS and CGSS, etc.).  It is also a good idea to perform these steps from a fresh power-on state so that any previous settings from applications won't affect the results.

* Open the Sound Control Panel by right-clicking the Windows Start button and selecting ''Control Panel''.
* Select ''Hardware and Sound'' from the Control Panel, then select ''Sound'' from the next window.
* From the Sound Control Panel select the ''Playback'' tab - you should see devices similar to this:


[[File:Usb8x8_Playback.PNG]]


* Right-click on ''USB 8x8 [0] Chan 3-4'' and select ''Properties''
* Click the ''Levels'' tab and set the volume level as shown below:


[[File:Usb8x8_Playback_Levels.PNG]]


* Close the ''Line Out Properties'' window by clicking ''OK''.
* From the Sound Control Panel select the ''Recording'' tab - you should see sound devices similar to this:


[[File:Usb8x8_Capture_Devices.PNG]]


* Right-click on ''USB 8x8 [0] Chan 3-4'' and select ''Properties''
* Click the ''Levels'' tab and set the volume levels as shown below:


[[File:Usb8x8_Capture_Levels.PNG]]


* Click the ''Listen'' tab.
* Click the checkbox for ''Listen to this device''.
* Use the drop-list below ''Playback through this device:'' to select ''Line Out (USB 8x8[0] Chan 3-4)''.
* Click ''Apply''.


[[File:Usb8x8_Listen.PNG]]


* You should now be able to hear inputs 3 & 4 being routed to outputs 3 & 4 (e.g. speak into the Commander microphone and you should hear your voice in the Commander headset).